Safety warning for construction of plastic stairs
A. Before installing plastic stairs
Check the stair surface (precast concrete or iron frame) to make sure it is flat, not warped, and not bumpy.
Do not place objects exceeding 200kg on the steps.
B. During construction of plastic stairs
In case of installation on concrete stairs
Measure and adjust the size of the step neck, step strip and step surface to fit the size of the staircase that needs to be covered.
Cover the cross-section of the step with a step strip.
Cover the stair treads first and then attach the treads.
Perform installation from bottom to top.
Use a rubber hammer to lightly tap the step neck and step face after installation to ensure tight fit.
Apply glue to the joint between the wall and the stairs to prevent dust from entering.
In case of installation on iron frame
Skeleton material: Square iron, galvanized steel, stainless steel.
Bone thickness: ≥ 1,4mm.
Main bar size: ≥30×30mm or 30×60mm.
Size of the ulna bar: ≥100×100mm.
Width of frame where step is installed: ≤280mm. Corresponds to step products with a width of 300mm.
Width of frame where step collar is installed: ≤200mm. Corresponds to products with step width of 200mm.
Distance between 2 horizontal bars: ≤8mm
Distance between 2 vertical bars: ≤27mm
C. After installing plastic stairs
Avoid direct sunlight, high temperature (over 50°C).
Avoid friction with hard or sharp objects.
Wipe with a damp cloth and a pH 6-8 solution.
Wipe down stairs immediately after spilling water.
Office: 281 Tan Son, Tan Son Ward, Ho Chi Minh City
