Instructions for constructing 2-sided plastic partitions with walkways

Installing 2-sided plastic partitions with walkways is an optimal space division solution, creating two separate functional areas (e.g., living room and dining area) while maintaining convenient circulation. The product brings high aesthetics with a wood grain surface and a quick and efficient installation process.

Materials and tools to prepare include: 2-sided plastic partition panel, bulkhead (acts as a frame and decorative accessory), special glue (Kosmos Glue), anchors, bolts, screws, straight angle bracket/right angle bracket, along with other basic tools like a laser measure, cutter, drill, hammer, and nail gun.

Step 1: Survey, measure and cut the base of the partition in case of leaving a path

You need to do the following 3 steps:

1. Identify exact location of partitions and walkways.
2. Measurement Overall and individual bar dimensions bulkhead.
3. Cut the wall by measurement: use angle 45 degrees for right angles and angles 90 degrees for straight joints.

Step 2: Prepare holes to fix the frame 2-sided plastic partition with walkway

The process of determining the holes to fix the bulkhead foot requires the following 3 steps:

1. Drill a pilot hole up the bulkhead bar.

2. Mark Position these holes on the floor, ceiling and walls.

3. Drill holes at the marked points on the construction site to close iron anchor/expansion anchor.

Step 3: Install the partition legs

3 steps to install partition feet on the wall

1. Close the plug (hatching) into the drilled holes.

2. Apply special glue on the wall to fix the base of the wall.

3. Place the wall foot in the glued position, adjust the drilled hole on the wall foot to match the expansion hole that has been driven into the wall. Then tighten the bolt/screw. to fix the wall foot. Use straight (12mm) for added strength.

Note: The wall must be firmly fixed in all 3 positions: Floor, walls and ceiling. At the joints, it is necessary to use glue and nail gun to link.

Step 4: Install the partition panel in case of leaving a path

3 steps to install the partition panel into the frame

1. Cut the partition panels according to measured dimensions.
2. Install the first wall panel into the grooves (upper and lower rails) of the frame
3. Continue to join the panels Based on the structure of negative and positive grooves, ensuring the panels fit tightly together.

Step 5: Finish the final edge

The process of finishing the final edge of the 2-sided plastic partition with walkway includes the following 2 steps:

1. Use a bar foot of the wall to cover the edge of the end panel.
2. Nail shooting to fix this wall foot at the locations: corner joints and along the wall edge with the panel.

Use a skirting board to cover the edge of the end panel.

Shoot nails to fix this wall base at the following locations: the connecting corners and along the edge of the wall with the panel.

Step 6: Check and handle cosmetic procedures 2-sided plastic partition with walkway

1. Check the tightness of all connections.
2. Use silicone glue to fill and cover small gaps (between the base of the wall and the wall, floor, ceiling). This helps the project achieve high aesthetics and prevents dust and dirt.

Watch the detailed video tutorial on how to install 2-sided plastic partitions:

The 6 steps to construct a 2-sided plastic partition with a walkway above have all the important notes. If you have any questions, please contact the number 0932.067.388, Kosmos customer service department will support as soon as possible.