Instructions for constructing 2-sided plastic partitions without leaving a walkway

Construction of 2-sided plastic partitions without leaving a walkway is a suitable choice when it is necessary to separate spaces, ensuring privacy for both areas. This wall has a relatively simple construction process but requires high precision in fixing.

Materials and tools to prepare: 2-sided plastic partition panel, bulkhead, special glue, anchors, bolts, screws, straight angle bracket/right angle bracket, and basic tools such as cutters, measuring tape, drills, and nail guns.

Step 1: Locate, measure and cut the base of the partition in case of no passage

To measure and install the partition accurately, follow these 3 steps:

1. Identify exact location of the partition installation.

2. Measurement overall size Cut the wall at 40° (compound angle) and 90° (straight connection).

3. For the foot of the wall Final (ceiling and floor), right slit in half lengthwise with length ≥400mm. This is necessary to thread the last baffle panel into the frame.

Step 2: Prepare holes to fix the frame 2-sided plastic partition without aisle

3 steps to create holes to fix the wall base to the floor, wall or ceiling.

1. Drill a pilot hole up the wall

2. Mark Location of holes drilled into floors, ceilings and walls.

3. Drill holes at the marked points on the construction site to prepare for closing plug

Step 3: Fix the partition legs

3 steps to fix the partition legs to the holes marked in step 2

1. Close the plug (hatching) into the bait hole

2. Apply special glue on the floor, wall, ceiling to fix the partition base.

3. Place the partition foot on the glued position, adjust the pilot hole on the partition foot to match the expansion bolt already installed on the wall. Then fix the stainless steel screw into the drilled hole and the expansion bolt through a 12mm wide straight bracket.

Note: The wall base frame must be tightly fixed at walls, ceilings, floors Use glue and nails to connect the corners.

Step 4: Install the partition panel in case of no passage

The partition panel is installed into the frame by the following 3 steps:

1. Cut the partition panel according to measured dimensions.

2. Install the wall panels one by one. into the frame groove, tightly fitted through the male and female groove structure.

3. For the last partition panel located close to the wall: The installation process of right angle (25mm) and screw to fix the partition panel to the wall (distance between brackets ≤40cm) to increase stability.

Watch a close-up video of how to install the end panel against the wall:

Step 5: Finish the end of the wall 2-sided plastic partition without aisle

1. Finishing the edge against the wall: Cut out the groove on the wall. Apply glue and stick this bar conceal the right angle brackets fixed in step 4, then shoot the nail to fix it.

2. Finishing the edges close to the ceiling and floor: The installation process of split wall (from Step 1). Apply glue, stick it in the end position, then nail it in place.

Step 6: Check and handle the aesthetics of the 2-sided plastic partition without leaving a passage

1. How to the cohesion and strength of the partition.
2. Use silicone glue to fill small gaps (between walls, ceilings, floors) to achieve the highest aesthetics and prevent dirt.

Above are 6 steps to construct 2-sided plastic partition without leaving a passage. Kosmos Vietnam is ready to advise you further via the number 0932.067.388